影视投资销售好做吗 宜兴旅游亮相中国国际旅交会  2022 0926-Mobile

山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽官方微信
郑重声明 购机 售后
您现在所在的位置: 首页> 新闻资讯 > 行业新闻 >

搅拌一体机维修保养小常识都有哪些内容?

所属分类:行业新闻 发布时间:2022-09-26 来源:http://www-shanqijituan-com.aplumproject.com 浏览量:18

新机器的走合保养是非常关键的,能延长机器的使用寿命,减少小故障的发生,今天小编带大家来看一下搅拌一体机维修保养小常识都有哪些内容?
The running in maintenance of the new machine is very key, which can prolong the service life of the machine and reduce the occurrence of small faults. Today, I'll take you to see what are the general knowledge of the maintenance of the integrated mixing machine?
1、详细阅读说明书,严格按照说明书进行操作保养。
1. Read the instructions carefully and operate and maintain in strict accordance with the instructions.
2、机器发动前绕车一周,检查油料/冷却液是否有缺失,轮胎气压新机器的走合保养是非常关键的,能延长机器的使用寿命,减少小故障的发生,今天小编带大家来看一下搅拌车维修保养小常识都有哪些内容?
2. Before starting the machine, go around the car and check whether there is any loss of oil / coolant. The running in maintenance of the new machine is very key. It can prolong the service life of the machine and reduce the occurrence of minor faults. Today, I'll take you to see what are the common sense of mixer maintenance?
1、详细阅读说明书,严格按照说明书进行操作保养。
1. Read the instructions carefully and operate and maintain in strict accordance with the instructions.
2、机器发动前绕车一周,检查油料/冷却液是否有缺失,轮胎气压及一些关键部位的螺栓松紧度,如传动轴,轮辋处的螺栓。
2. Before starting the machine, go around and check whether the oil / coolant is missing, the tire pressure and the bolt tightness of some key parts, such as the bolts at the transmission shaft and rim.
3、机器启动后怠速运转3-5分钟(尤其是冬天寒冷地区),熄火时同样操作。
3. After the machine is started, operate at idle speed for 3-5 minutes (especially in cold areas in winter), and do the same when the engine is turned off.
4、新车走合期间,机器不能过载,保证机器输出功率不超过额定功率的70,否则会导致早期故障的出现(如三漏)。
4. During the running in of the new car, the machine shall not be overloaded to ensure that the output power of the machine does not exceed 70 of the rated power, otherwise it will lead to early faults (such as three leaks).
5、各个档位都要走合。
5. All gears shall be engaged.
6、操作期间注意仪表盘仪表的指示,确保整机在规定的范围内工作,如果仪表出现异常,请立即停机检查。
6. Pay attention to the instructions of the instrument panel during operation to ensure that the whole machine works within the specified range. If the instrument is abnormal, please stop the machine immediately for inspection.
7、注意关键部件的温度,如桥/箱等,若出现高温现象,立即停机检查。
7. Pay attention to the temperature of key components, such as bridge / box. In case of high temperature, stop the machine immediately for inspection.
8、走合结束后,将关键部位的螺栓全部检查,包括驱动桥/发动机/变速箱固定螺栓,传动轴螺栓等螺栓的禁锢情况。
8. After running in, check all bolts at key parts, including the confinement of fixing bolts of drive axle / engine / gearbox and transmission shaft bolts.
9、走合结束,根据操作保养手册规定,更换油料及滤芯。
9. After running in, replace the oil and filter element according to the provisions of the operation and maintenance manual.
走合结束后,除了根据操保手册的规定进行定期保养外,也要注意以下几点:
After running in, in addition to regular maintenance according to the provisions of the operation and maintenance manual, pay attention to the following points:
1、一定用规定的润滑油及滤芯,否则会降低机器的使用寿命。
1. The specified lubricating oil and filter element must be used, otherwise the service life of the machine will be reduced.
2、不同季节用不同型号的油料。
2. Different types of oil are used in different seasons.
3、不同型号或同型号不同品牌的油或制动液不能混用。
3. Oil or brake fluid of different models or different brands of the same model shall not be mixed.
4、不能对机器进行私自改装,那样厂家将不会提供三包。及一些关键部位的螺栓松紧度,如传动轴,轮辋处的螺栓。
4. The machine cannot be modified without permission, so the manufacturer will not provide three guarantees. And the bolt tightness of some key parts, such as the bolts at the transmission shaft and rim.
3、机器启动后怠速运转3-5分钟(尤其是冬天寒冷地区),熄火时同样操作。
3. After the machine is started, operate at idle speed for 3-5 minutes (especially in cold areas in winter), and do the same when the engine is turned off.
4、新车走合期间,机器不能过载,保证机器输出功率不超过额定功率的70,否则会导致早期故障的出现(如三漏)。
4. During the running in of the new car, the machine shall not be overloaded to ensure that the output power of the machine does not exceed 70 of the rated power, otherwise it will lead to early faults (such as three leaks).
5、各个档位都要走合。
5. All gears shall be engaged.
6、操作期间注意仪表盘仪表的指示,确保整机在规定的范围内工作,如果仪表出现异常,请立即停机检查。
6. Pay attention to the instructions of the instrument panel during operation to ensure that the whole machine works within the specified range. If the instrument is abnormal, please stop the machine immediately for inspection.
7、注意关键部件的温度,如桥/箱等,若出现高温现象,立即停机检查。
7. Pay attention to the temperature of key components, such as bridge / box. In case of high temperature, stop the machine immediately for inspection.
8、走合结束后,将关键部位的螺栓全部检查,包括驱动桥/发动机/变速箱固定螺栓,传动轴螺栓等螺栓的禁锢情况。
8. After running in, check all bolts at key parts, including the confinement of fixing bolts of drive axle / engine / gearbox and transmission shaft bolts.
9、走合结束,根据操作保养手册规定,更换油料及滤芯。
9. After running in, replace the oil and filter element according to the provisions of the operation and maintenance manual.
走合结束后,除了根据操保手册的规定进行定期保养外,也要注意以下几点:
After running in, in addition to regular maintenance according to the provisions of the operation and maintenance manual, pay attention to the following points:
1、一定用规定的润滑油及滤芯,否则会降低机器的使用寿命。
1. The specified lubricating oil and filter element must be used, otherwise the service life of the machine will be reduced.
2、不同季节用不同型号的油料。
2. Different types of oil are used in different seasons.
3、不同型号或同型号不同品牌的油或制动液不能混用。
3. Oil or brake fluid of different models or different brands of the same model shall not be mixed.
4、不能对机器进行私自改装,那样厂家将不会提供三包。
4. The machine cannot be modified without permission, so the manufacturer will not provide three guarantees.

 

av年轻的母亲 波多野结衣家门口AV av5200 亚洲AV网站每日更新 小小萝莉av
av大全无码看片 日本av男优大全 酒吧av网站 十次av高清伦理 在线av800
茄子影院av 猫咪av新闻是什么app xfplay电影Av网 里克福克斯av 猫咪av最新永久网址
av天堂网bt2017 美女与狗狗av 2018欧美最新av女星 美女在线av 大桥未久-av在线观看